ALC - Aerodyne

Not only do NFPA regulations require a DHA (Dust Hazard Analysis) to be done on all systems that might have explosive dust, they also require the DHA to be updated every 5 years and whenever the system changes. 

We all know that getting the oil change in our car regularly is important to the car being able to get you around when you need it.  However, your dust collector needs regular maintenance too.  The dust collector system consists of hoods, ductwork, air-material separators (cyclones, baghouse, cartridge collectors, wet scrubbers, etc.), explosion protection equipment, airlocks, instrumentation, and exhaust fans. 

When it is time to add a dust collector to your application, you have to find a place for the dust collector.  This isn’t always easy.  New facilities are usually designed around the equipment that is being installed.  However when a system in an existing facility is modified or installed, you will have limited space to install the dust collector system.  There are four factors that you should take into account when finding a place for your dust collector. (Part 4 of 4)

When it is time to add a dust collector to your application, you have to find a place for the dust collector.  This isn’t always easy.  New facilities are usually designed around the equipment that is being installed.  However when a system in an existing facility is modified or installed, you will have limited space to install the dust collector system.  There are four factors that you should take into account when finding a place for your dust collector. (Part 2 of 4)

OSHA is issuing citations and fines to companies with unsafe combustible dust hazards, using their general duty clause and NFPA 652: Standard on the Fundamentals of Combustible Dust as a guideline. Any industrial facility that creates dusts or uses powders was mandated by NFPA 652 to complete a Dust Hazard Analysis by September, 2020 to identify the presence of combustible dusts and establish a plan for eliminating or mitigating potential risks associated with these dusts in their facilities. The DHA is essentially the framework around which NFPA 652 is built, and the starting point for getting a facility into compliance with the standard as a whole.

When it is time to add a dust collector to your application, you have to find a place for the dust collector.  This isn’t always easy.  New facilities are usually designed around the equipment that is being installed.  However when a system in an existing facility is modified or installed, you will have limited space to install the dust collector system.  There are four factors that you should take into account when finding a place for your dust collector. (Part 1 of 4)

The most basic reason to install dust collectors is because the EPA, OSHA or other regulatory agency requires you to.  However there are other reasons to install a dust collector even if you aren’t required to.