ALC - Aerodyne

Dust collectors have hoppers under the collection chambers to channel the dust out of the system for use or disposal. The hoppers are not designed to be used to collect and store the material, but rather as a place for the material to temporarily collect before passing through the airlock and out of the system. 

When you are designing your ductwork, there are two ways you can do it. 1) You can use dampers to control the airflow at each pickup and balance the system or 2) You can balance by design which means the ductwork is designed so that the proper airflow goes through each pickup without the need to install dampers. There are positives and negatives with both. The following will go over them.

Hygroscopic dust can really grow on your nerves! I know the marketing department might take away my writing duties after that line. But seriously, hygroscopic dust can cause major maintenance issues in your dust collectors. Hygroscopic dust captures water vapor and droplets. This causes the particles to grow in size and weight, thereby making them easier to capture and remove from the airstream. However, if you are using filters, that’s where the problems start.

Dust collection filters such as the bags in baghouses, cartridges in cartridge collectors, and HEPA filters all filter out dust particles by collecting them in between their fibers. Dust builds up on the bags and cartridges to form a filter cake over the filter further restricting the ability of dust particles and airflow to pass through the filter. This restricting of airflow causes a pressure drop (resistance) which is directly related to the amount of dust built up on the filters. As the pressure drop increases, the airflow through the collector will decrease. Most baghouses and cartridge collectors have cleaning cycles which remove some of the dust from the filters keeping the pressure drop low.

Dust collectors are required in facilities for multiple reasons. After installation, they are often forgotten about until something isn’t working right.  In order to fix the problem, the system has to be almost re-engineered to figure out what the design originally was. The following things are signs your dust collector isn’t working how it was designed and you need to perform a checkup.

When selecting the best cyclone for your process, there are many different factors that affect the sizing and cost of the cyclone.  The cyclone must be sized so that it handles the airflow of the system and components.  The proper design for the required removal efficiency must be used.  The process will also dictate the materials of construction and special requirements.  The location where the cyclone will be installed will influence the cyclone orientation.  Cyclones aren’t a stand-alone piece of equipment; support equipment is required for proper operation.  Therefore, the scope of supply will affect the cyclone costs and design.  The following is a brief description of the different elements that affect cyclone sizing and pricing.

Dust collection systems require the proper airflow to operate correctly.  Without the correct air flow, dust will not be removed from collection points and the collection equipment (baghouse, cartridge collectors, cyclones, etc.) will not operate with maximum efficiency. However, if too much air is being pulled through the system, a variety of issues might ensue, such as product being lost, removal efficiency lowered, utility usage increased.

Heavy dust loading in the dust collector leads to high maintenance dust collectors.  Since most dust collectors are fabric filters (baghouse, cartridge collectors, shakers, etc.), heavy dust loading will cause/require high frequency of cleaning of the filters.  Most filters are cleaned by injecting high pressure air into the clean side, causing the filters to expand a bit.  This causes dust to fall off the filters.  Filters wear out due to the frequent expanding and contracting.  So the more often you have to clean a filter, the faster the filters will wear out.

We all know that getting the oil change in our car regularly is important to the car being able to get you around when you need it.  However, your dust collector needs regular maintenance too.  The dust collector system consists of hoods, ductwork, air-material separators (cyclones, baghouse, cartridge collectors, wet scrubbers, etc.), explosion protection equipment, airlocks, instrumentation, and exhaust fans.